lyophilisation comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Updated 2025-11-22. Numbers and descriptions here follow the published literature rather than marketing material.
The two variants differ dramatically in how long they persist in circulation. The form lacking the albumin-binding group has a plasma half-life measured in tens of minutes, comparable to the natural hormone fragment. The version carrying the drug affinity complex binds albumin and shows a half-life of roughly six to eight days in human studies. That figure comes from small trials that tracked hormone levels over extended periods. The physiological consequences of sustained versus pulsatile stimulation are still debated and the literature does not settle the point.
Lyophilized peptide powder is comparatively stable when kept dry, cold, and protected from light. Once dissolved, the molecule is vulnerable to deamidation, oxidation, and aggregation, with the rate depending on pH, buffer composition, and temperature. Alkaline conditions and repeated freeze-thaw cycles accelerate loss of the intact peptide. The methionine present in the native sequence is a known oxidation site, which is one reason it was replaced in the modified fragment. Suppliers typically recommend cold storage of solutions and use within a short window.
CJC-1295 is a synthetic analogue of growth hormone-releasing hormone, built on the 29-amino-acid GHRH(1-29) fragment. Four substitutions distinguish it from the natural sequence: D-alanine at position 2, glutamine at position 8, alanine at position 15, and leucine at position 27. These changes reduce enzymatic cleavage and extend the peptide's persistence in circulation. The compound is discussed in two forms, one carrying a drug affinity complex and one without it.
The drug affinity complex is a maleimidopropionic acid group attached to a lysine side chain. It reacts with the free thiol of cysteine-34 on circulating albumin, forming a covalent bond. This conjugation keeps the peptide in the bloodstream and shields it from rapid renal filtration and proteolysis. Reported circulation half-lives for the albumin-bound form fall in the range of roughly six to nine days in early human studies.
Binding to GHRH receptors on pituitary somatotroph cells triggers cyclic AMP signaling and stimulates growth hormone synthesis and release. Because the peptide acts upstream of the pituitary, effects are mediated through endogenous growth hormone rather than direct receptor activation in peripheral tissues. Increases in insulin-like growth factor 1 are generally described as a downstream consequence. Most published human exposure data come from small early-stage studies, and the clinical significance of the pharmacokinetic profile remains incompletely characterized.
| Property | Value | Notes |
|---|---|---|
| Molecular mass | Approximately 3.4 to 3.6 kDa | Depends on whether the affinity complex is attached |
| Appearance | White to off-white lyophilized powder | Freeze-dried solid, often in a sealed vial |
| Solubility | Soluble in water and aqueous buffers | Dissolution rate varies with pH and buffer salt |
| Typical storage | Below minus 20 degrees Celsius, dry and dark | Dissolved material is usually kept cold and used promptly |
| Common analytical methods | Reversed-phase HPLC and mass spectrometry | Peptide mapping and amino acid analysis add sequence detail |
The peptide backbone corresponds to GRF(1-29), the first 29 residues of native growth hormone-releasing hormone, which retains most of the receptor-activating activity of the full-length molecule. Four substitutions distinguish the analog from the natural sequence: D-alanine at position 2, glutamine at position 8, alanine at position 15, and leucine at position 27. These changes slow cleavage by dipeptidyl peptidase IV, the enzyme that degrades native hormone in plasma within minutes. The outcome is improved enzymatic stability combined with a still brief residence time when no additional modification is present.
Naming in this area is inconsistent, and readers should treat product labels with care. In much of the literature and in vendor catalogs, the unqualified term refers to the albumin-binding version, while the version lacking the DAC group appears as modified GRF(1-29), mod GRF(1-29), or the same name with a without-DAC qualifier. Because one abbreviation has been applied to both materials, the only reliable way to identify a sample is to check the stated sequence and the presence of the linker.
Lyophilised powder is the usual supplied form. The material is hygroscopic, so vials are typically equilibrated to room temperature before opening in order to prevent condensation on the contents. Long-term storage is generally described at minus twenty degrees Celsius or colder, protected from light and moisture. Repeated freeze-thaw cycles are avoided because they promote aggregation and loss of soluble material. A reconstituted solution is considerably less stable than the dry powder and is normally kept refrigerated for short periods only.
Identity and purity are assessed mainly by reversed-phase high-performance liquid chromatography combined with mass spectrometry. The chromatographic separation resolves the target peptide from truncation products and from species carrying oxidised residues, while mass measurement confirms the expected molecular mass. Because the two common variants differ by roughly 280 daltons, a mass determination distinguishes them unambiguously. Purity is often quoted as a percentage of total peak area, although that figure depends on the detection wavelength and the integration method applied.
Reported half-lives differ widely between the two variants and between species. Values for the albumin-binding form are usually expressed in days, while the unconjugated form is measured in minutes to a few hours. Sampling schedules, assay sensitivity, and route of administration all influence the numbers, which limits direct comparison across studies. Whether sustained receptor occupancy produces different downstream effects from pulsatile stimulation remains an open question in the published work. Claims about relative potency should therefore be read alongside the specific study design that produced them.
The compound emerged from work at a Canadian biotechnology firm in the early 2000s. Early human studies examined its effect on growth hormone and insulin-like growth factor 1 in healthy volunteers and in people with HIV-associated fat redistribution. Reports described sustained increases in both markers after a single injection. Development did not advance to regulatory approval, and the clinical programme was later discontinued. The molecule is now encountered mainly as a research chemical rather than a marketed medicine.
Two forms circulate in research settings and are frequently confused. One carries the drug affinity complex and is often written as CJC-1295 with DAC; the other lacks that group and is usually called modified GRF(1-29). The two share the same core sequence but differ sharply in how long they persist in blood. Products labelled only as CJC-1295 normally refer to the version carrying the complex. Documentation that omits the distinction leaves the intended molecule ambiguous.
CJC-1295 is a synthetic peptide built as a long-acting analogue of growth hormone-releasing hormone. Its backbone matches the first twenty-nine residues of the natural human hormone, with four amino acid substitutions added to slow enzymatic breakdown. A reactive maleimide group, commonly termed the drug affinity complex, allows the peptide to attach to circulating albumin after administration. That albumin attachment keeps the molecule in the bloodstream for an extended period instead of being cleared within minutes.
CJC-1295 is a synthetic peptide designed as a long-acting analogue of growth hormone-releasing hormone (GHRH). Its structure derives from the first 29 amino acids of native GHRH, a fragment often called GRF(1-29). Four substitutions were introduced to slow enzymatic breakdown and extend activity relative to the natural sequence. The compound was developed by ConjuChem as part of a broader effort to improve the pharmacokinetic profile of peptide hormones. It is studied in laboratory and clinical research settings rather than appearing as a naturally occurring substance.
Two related forms circulate in technical discussion under the same family name. The original version carries a drug affinity complex (DAC) that binds covalently to serum albumin after administration, and this linkage substantially extends circulation time. A second form, frequently written as modified GRF(1-29) or CJC-1295 without DAC, lacks that linker and clears much faster. The naming is a frequent source of confusion because the shorthand CJC-1295 can refer to either form depending on the source. Reports sometimes fail to specify which variant was studied.
The peptide backbone includes a D-alanine at position two, which resists cleavage by dipeptidyl peptidase IV, and several other substitutions that reduce degradation. Its molecular weight is roughly 3.4 kDa without the linker and about 3.6 kDa with it. The molecule is water soluble and is normally supplied as a lyophilized powder. Precise sequence and mass values depend on which variant is described, so technical documents usually state the exact form being referenced.
Acetyl phosphate (AcP), a precursor to ATP, can readily be synthesized at modest yields from thioacetate in pH 7 and 20 °C and pH 8 and 50 °C, although acetyl phosphate is less stable in warmer temperatures and alkaline conditions than in cooler and acidic to neutral conditions. It is unable to promote polymerization of ribonucleotides and amino acids and was only capable of phosphorylation of organic compounds. It was shown that it can promote aggregation and stabilization of AMP in the presence of Na+, aggregation of nucleotides could promote polymerization above 75 °C in the absence of Na+. It is possible that polymerization promoted by AcP could occur at mineral surfaces. It was shown that ADP can only be phosphorylated to ATP by AcP and other nucleoside triphosphates were not phosphorylated by AcP. This might explain why all lifeforms use ATP to drive biochemical reactions.
Chemical antagonism occurs when a chemical antagonist combines with a ligand to form an inactive product compound, inhibiting the response. In chemical antagonism, the receptors are not involved in the process, and the antagonist directly binds with or removes the ligand. It prevents the ligand from binding to the receptor. As the ligand cannot stimulate the receptor, no physiological effect is generated by the receptors and thus provides an inhibitory effect. The common types of chemical antagonism include chelating agents, neutralising antibodies and salt aggregation.
In 1969, after completing her medical training, she became a lecturer at the Department of Bacteriology and Immunology in Glasgow's Western Infirmary teaching hospital. While working at the hospital she carried out research on the role of intra-epithelial lymphocytes in intestinal immunity, receiving her PhD in 1974. In 1975, she was appointed as a senior lecturer at the University of Edinburgh, also becoming a consultant at the Gastrointestinal Unit at the Western General Hospital in Edinburgh. In 1987 she was appointed to a personal professorship in gastroenterology. From 1991 to 1994 she was head of the Department of Medicine at the university. She published more than 250 papers in peer-reviewed academic journals, published three books and contributed chapters to many other books. Her research provided new insights into the mechanisms responsible for Crohn's and coeliac diseases which led to significant advances in the therapy of these conditions. She also carried out significant research on oral tolerance. She served on the Committee on Safety of Medicines, the Medical Research Council Gene Therapy Advisory Board, and the Spongiform Encephalopathy Advisory Committee. At the time of her death she was president of the Society for Mucosal Immunology. She was a consultant providing advice and training to the International Centre for Diarrhoeal Disease Research in Bangladesh.
Sources: en.wikipedia.org
The formylglycine tag or aldehyde tag is a convenient 6- or 13-amino acids long tag fused to a protein of interest. The 6-mer tag represents the small core consensus sequence and the 13-mer tag the longer full motif. The experiments on the genetically encoded aldehyde tag by clearly showed the high conversion efficiency with only the core consensus sequence present. Four proteins were produced recombinantly in E.coli with an 86% efficiency of for the full-length motif and >90% efficiency for the 6-mer determined by mass spectrometry. The size of the sequence is analogous to the commonly used 6x His-Tag and has the advantage that it can also be genetically encoded. The sequence is recognized in the ER solely depending on primary sequence and subsequently targeted by FGE. Notably, in the setup of recombinant expression proteins in E. coli a coexpression of exogenous FGE aids full conversion, although E. coli has endogenous FGE-activity. The introduction of an aldehyde tag has a workflow that consists of three segments: A the expression of the fusion protein, that carries the peptide tag derived from the sulfatase motif, B the enzymatic conversion of Cys to f(Gly) and C the bioorthogonal probing with hydrazides or alkoxy amines (Fig. 1).
There are at least three known isoforms of this protein in humans produced by alternative splicing: isoform 1, of length 442 amino acids, isoform 2 of length 261 amino acids and isoform 3 of length 169 amino acids. MIPOL1 contains two coiled-coil domains in its C-terminus at positions 107 – 212 and 253 – 435 (shown in Fig.1). A bipartite nuclear localization signal is predicted at position 128 – 143. The following post-translational modifications are predicted using bioinformatics tools for MIPOL1. Multiple phosphorylation sites are predicted for this protein, that are conserved in close orthologs, including a Casein kinase 1 (CK1) site, three Casein kinase 2 (CK2) sites, and three NEK2 sites. The exact structure of the MIPOL1 has not yet been characterized. Homology-based and de novo predictions of its tertiary structure suggest that it may consist of inter-twined alpha helices, forming coiled-coil domains (see Fig.4.).
Acta Biochimica et Biophysica Sinica (ABBS) is a peer-reviewed scientific journal which publishes original research articles, short communications, and reviews in the fields of biochemistry and biophysics. Established in 1958, the journal is sponsored by the Institute of Biochemistry and Cell Biology, an institute of the Chinese Academy of Sciences, and is published monthly by Oxford Journals and was published by Blackwell Publishing prior to January 2009. This journal is indexed in the following databases: Science Citation Index Expanded Zoological Record BIOSIS Previews Chemical Abstracts Service – CASSI Index medicus MEDLINE PubMed
A rare development is amyloid purpura, a susceptibility to bleeding with bruising around the eyes, termed "raccoon-eyes". Amyloid purpura is caused by amyloid deposition in the blood vessels and reduced activity of thrombin and factor X, two clotting proteins that lose their function after binding with amyloid. Amyloid deposits in tissue can cause enlargement of structures. Twenty percent of people with AL amyloidosis have an enlarged tongue, that can lead to obstructive sleep apnea, difficulty swallowing, and altered taste. Tongue enlargement does not occur in ATTR or AA amyloidosis. Deposition of amyloid in the throat can cause hoarseness.
Sources: en.wikipedia.org
The version carrying the affinity complex bears a maleimide group that binds serum albumin, which extends its circulation time to several days. The version without it lacks this group and clears within roughly half an hour. The two are chemically related but behave very differently once in the body.
In common usage the name without the affinity complex is often equated with MOD GRF 1-29, a fragment carrying four stabilizing substitutions. Strictly speaking, the term originally referred to the albumin-binding version. The overlap in naming causes frequent ambiguity in both informal and technical writing.
Reversed-phase chromatography separates the peptide from related impurities and yields a purity estimate. Mass spectrometry confirms the molecular mass and detects modifications such as oxidation. Sequence-level checks rely on peptide mapping or amino acid analysis when stronger confirmation is needed.
The two share the same 29-amino-acid backbone. CJC-1295 carries an additional albumin-binding moiety that markedly extends its residence time in circulation, while the form without that moiety clears faster. Literature sometimes applies the name loosely to either variant.