The short version of GRF(1-29) fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-12-05 and is reviewed periodically as new material appears.
Naming in this area is inconsistent, and readers should treat product labels with care. In much of the literature and in vendor catalogs, the unqualified term refers to the albumin-binding version, while the version lacking the DAC group appears as modified GRF(1-29), mod GRF(1-29), or the same name with a without-DAC qualifier. Because one abbreviation has been applied to both materials, the only reliable way to identify a sample is to check the stated sequence and the presence of the linker.
CJC-1295 is the name used for a synthetic peptide modeled on growth hormone-releasing hormone, the hypothalamic signal that prompts the pituitary to release growth hormone. The compound was described by a Canadian drug discovery company in the mid-2000s as a long-acting research tool. Two closely related molecules share the name in practice: one carries a drug affinity complex, or DAC, group, and one does not. The distinction matters because the two behave differently in circulation.
Reconstitution is typically performed with sterile water or bacteriostatic water, added slowly against the vial wall. The resulting solution should be clear and colorless; cloudiness or visible particles suggest a problem with the material or the diluent. Once in solution, the peptide is less stable than the dry powder. Refrigerated storage at two to eight degrees Celsius is common for short-term holding, while freezing aliquots is described for longer periods.
Purity is most often assessed by reversed-phase high-performance liquid chromatography, reported as a percentage of total peak area. Identity is confirmed by mass spectrometry, which yields a molecular ion consistent with the expected sequence. Amino acid analysis and peptide mapping provide additional characterization. Reported purity values are method-dependent, so figures from different laboratories are not always directly comparable without details of column, gradient, and detection wavelength.
Peptide degradation proceeds mainly through hydrolysis, oxidation of methionine, and deamidation of asparagine or glutamine residues. The maleimide group on the albumin-binding variant can also react with thiols or hydrolyze in aqueous media. Because these pathways accelerate with temperature and pH extremes, handling conditions strongly influence measured stability. Stability data in the public literature are limited and often generated under differing conditions, so general statements about shelf life should be read as approximate.
| Property | Value | Notes |
|---|---|---|
| Molecular class | Synthetic peptide | GHRH analog, not a steroid |
| Backbone length | 29 amino acids | Based on GRF(1-29) |
| Substitutions | Four positions | D-Ala2, Gln8, Ala15, Leu27 |
| Appearance | White to off-white powder | Typical lyophilized research material |
| Common synonyms | Modified GRF(1-29) | Usage varies between sources |
Identity and purity are established with reversed phase high performance liquid chromatography coupled to mass spectrometry. The chromatographic step separates the target peptide from truncated sequences and deletion products, while the mass measurement confirms the expected molecular weight to within a fraction of a dalton. Because the two common variants differ by the presence of the linker, mass alone can distinguish them in the unconjugated state. Amino acid analysis and peptide mapping are used when sequence level confirmation is required.
Lyophilized material is generally stable for extended periods when held at minus twenty degrees Celsius or below and protected from moisture and light. In solution the peptide is more labile; bond hydrolysis, aggregation and oxidation of susceptible residues all proceed faster at ambient temperature. Repeated freeze and thaw cycles should be avoided because they promote clumping and loss of soluble material. The conjugated variant adds a further consideration, since the maleimide group can hydrolyze in aqueous buffer and lose its ability to react with albumin.
CJC-1295 is a synthetic peptide analog of growth hormone-releasing hormone, constructed on the 29-amino-acid fragment designated GRF(1-29). The name began as an internal development code during the 1990s and later spread through research supply catalogs and discussion forums. The molecule does not occur in nature; its sequence is engineered rather than isolated from tissue. Two related compounds are sold under this single label, and they differ by one appended chemical group that strongly influences how long the peptide remains in circulation.
The dividing feature between the two forms is a maleimide-based drug affinity complex, abbreviated DAC. In the DAC-bearing version, a linker attaches the peptide to serum albumin after administration, and that association slows removal from plasma. The version lacking DAC appears in catalogs as MOD GRF(1-29) or tetrasubstituted GRF(1-29). Because informal writing treats both as one item, comparisons drawn from such sources routinely blend measurements taken from two molecules with substantially different behavior.
Four amino acid substitutions separate the modified backbone from the parent GRF(1-29) sequence. These changes reduce recognition by dipeptidyl peptidase IV and related proteases, extending the interval before degradation. Development work in this area sought longer-acting GHRH analogs for endocrine investigation. Published descriptions treat the substitution set as a defining property of the core sequence, while the albumin-binding linker is described separately as an optional addition to that same backbone.
Stability depends heavily on physical state. A lyophilized powder kept dry, desiccated, and shielded from light typically holds its integrity for months to years at minus twenty degrees Celsius, and longer at minus eighty. Once dissolved, the peptide becomes far more vulnerable, since peptide bond hydrolysis, oxidation of susceptible residues, and aggregation all proceed faster in solution. Buffers near neutral pH are generally gentler than strongly acidic or alkaline conditions. Repeated freeze-thaw cycles and exposure to air-liquid interfaces during vigorous mixing cause losses that are easy to overlook.
Verification matters because research peptides vary widely in quality. A certificate of analysis is only as reliable as the method behind it, and a single chromatographic trace reveals little about counter-ions, residual solvents, or water content. Independent laboratories commonly pair mass confirmation with chromatographic purity and, where relevant, quantify water along with acetate or trifluoroacetate content. Reported purity figures are not standardized across suppliers, so a stated value such as ninety-eight percent is not directly comparable unless the analytical method, column, and detection wavelength accompany it.
In order for a protonated acid to lose a proton, the pH of the system must rise above the pKa of the acid. The decreased concentration of H+ in that basic solution shifts the equilibrium towards the conjugate base form (the deprotonated form of the acid). In lower-pH (more acidic) solutions, there is a high enough H+ concentration in the solution to cause the acid to remain in its protonated form. Solutions of weak acids and salts of their conjugate bases form buffer solutions. To determine the concentration of an acid in an aqueous solution, an acid–base titration is commonly performed. A strong base solution with a known concentration, usually NaOH or KOH, is added to neutralize the acid solution according to the color change of the indicator with the amount of base added. The titration curve of an acid titrated by a base has two axes, with the base volume on the x-axis and the solution's pH value on the y-axis. The pH of the solution always goes up as the base is added to the solution.
The Bergmann degradation is a series of chemical reactions designed to remove a single amino acid from the carboxylic acid (C-terminal) end of a peptide. First demonstrated by Max Bergmann in 1934, it is a rarely used method for sequencing peptides. The later developed Edman degradation is an improvement upon the Bergmann degradation, instead cleaving the N-terminal amino acid of peptides to produce a hydantoin containing the desired amino acid. The Bergmann degradation follows the earlier work of Bergmann and his close colleague Leonidas Zervas, combining the organic azide degradation of the Curtius rearrangement with the Bergmann-Zervas carbobenzoxy method, which they designed to occur under relatively mild conditions so as to allow peptide sequencing. A single round of the Bergmann degradation yields an aldehyde containing the sought after amino acid residue and the remaining fragment of the original peptide in amide form.
Antimicrobial peptides generally have a net positive charge, allowing them to interact with the negatively charged molecules exposed on bacteria and cancer cell surfaces, such as phospholipid phosphatidylserine, O-glycosylated mucins, sialylated gangliosides, and heparin sulfates. The mechanism of action of these peptides varies widely but can be simplified into two categories: membranolytic and non-membranolytic antimicrobial peptides. The disruption of membranes by membranolytic antimicrobial peptides can be described by four models:
Automated synthesis systems find new applications with a development of new robotic platforms. Possible applications include: uncontrolled synthesis, time-dependent synthesis, radiosynthesis, synthesis in demanding conditions (low temperatures, presence of specific atmosphere like CO, H2, N2, high pressure or under vacuum) or whenever the same or similar workflow needs to be applied multiple times with the aim to: optimize reactions, synthesize many derivatives in small scale, perform reactions of iterative homologations or radiosynthesis. Automated synthesis workflows are needed both in academic research and a wide array of industrial R&D settings (pharmaceuticals, agrochemicals, fine & specialty chemicals, renewables & energy research, catalysts, polymers, ceramics & abrasives, porous materials, nanomaterials, biomaterials, lubricants, paints & coatings, home care, personal care, nutrition, forensics).
Sources: en.wikipedia.org
The protein encoded by the DLD gene comes together with another protein to form a dimer in the central metabolic pathway. Several amino acids within the catalytic pocket have been identified as important to DLD function, including R281 and N473. Although the overall fold of the human enzyme is similar to that of yeast, the human structure is different in that it has two loops that extend from the general protein structure and into the FAD binding sites when bound the NAD+ molecule, required for catalysis, is not close to the FAD moiety. However, when NADH is bound instead, it is stacked directly op top of the FAD central structure. The current hE3 structures show directly that the disease-causing mutations occur at three locations in the human enzyme: the dimer interface, the active site, and the FAD and NAD(+)-binding sites.
Agile Manufacturing is a modern production approach that enables companies to respond swiftly and flexibly to market changes while maintaining quality and cost control. This methodology is designed to create systems that can adapt dynamically to changing customer demands and external factors such as market trends or supply chain disruptions. It is mostly related to lean manufacturing. While Lean Manufacturing focuses primarily on minimizing waste and increasing efficiency, Agile Manufacturing emphasizes adaptability and proactive responses to change. The two approaches are complementary and can be combined into a “leagile” system, which balances cost efficiency with flexibility. The principles of Agile Manufacturing, with its focus on flexibility, responsiveness to change, collaboration, and delivering customer value, serve as a foundation for the later development of Agile Software Development.
Aldo Carl Leopold (December 18, 1919 – November 18, 2009) was an American academic and plant physiologist, son of Aldo Leopold, a noted ecologist. He is known for his research on soybeans which led to techniques allowing insulin to be dried and later processed into an inhalable insulin. Aldo Carl Leopold was born to Aldo Leopold, a noted ecologist and employee of the United States Forest Service, and Estella Leopold in Albuquerque, New Mexico as the 4th of 5 children.
Sources: en.wikipedia.org
No. It is a laboratory-made analog of growth hormone-releasing hormone. The natural hormone is a 44-residue peptide, while the analog is built on a shorter 29-residue fragment.
The original material included a linker that binds serum albumin. A later variant removed that linker to reduce the duration of action. Catalogs and papers did not consistently adopt separate names, so both remain widely labeled with the same term.
The amino acid sequence and the presence or absence of the linker group. Mass measured by spectrometry gives an independent check that separates the two forms.
Cool, dark, and dry conditions are standard, with storage at minus twenty degrees Celsius or below. Desiccant and sealed vials limit moisture uptake. Repeated warming and cooling of the container is generally avoided.